Perpustakaan Digital ITB

The effective development of unconventional tight oil formations, such as Bakken, could include CO2 enhanced oil recovery (EOR) technologies with associated benefits of capturing and storing large quantities of CO2. It is important to conduct the gas injection at miscible condition so as to reach maximum recovery efficiency. Therefore, determination of the minimum miscibility pressure (MMP) of reservoir live oileinjection gas system is critical in a miscible gas flooding project design. In this work, five candidate injection gases, namely CO2, CO2-enriched flue gas, natural gas, nitrogen, and CO2-enriched natural gas, were selected and their MMPs with a Bakken live oil were determined experimentally and numerically. At first, phase behaviour tests were conducted for the reconstituted Bakken live oil and the gases. CO2 outperformed other gases in terms of viscosity reduction and oil swelling. Rising bubble apparatus (RBA) determined live oileCO2 MMP as 11.9 MPa and all other gases higher than 30 MPa. The measured phase behaviour data were used to build and tune an equation-of-state (EOS) model, which calculated the MMPs for different live oilgas systems. The EOS-based calculations indicated that CO2 had the lowest MMP with live oil among the five gases in the study. At last, the commonly-accepted Alston et al. equation was used to calculate live oilepure CO2 MMP and effect of impurities in the gas phase on MMP change. The Bakken oileCO2 had a calculated MMP of 10.3 MPa from the Alston equation, and sensitivity analysis showed that slight addition of volatile impurities, particularly N2, can increase MMP significantly